DEMO Drop Stitch Micro Speed Boat for Electric Fin Drive
Condition: USED – NOT NEW
Manufacturer's Sample – One-Person Inflatable Micro Boat
This is a manufacturer’s sample of a compact, one-person inflatable micro boat made entirely from 80mm drop stitch material, featuring a built-in inflatable seat.
The boat was designed for use with remote-controlled electric fins, such as the K4C or K4S, for improved speed and performance.
The boat also features rear D-rings for attaching an optional motor mount. If installing an electric fin directly underneath the boat is not practical, the fin can instead be installed using an optional transom adapter attached to a motor mount. Compatible accessories are available in our Accessories section.
You can use this boat with your own compatible electric fin or purchase one of the recommended electric fins and accessories shown on the right side of this page.
Specifications
- Construction: Fully inflatable 80mm drop stitch material
- Air Pressure: 8–10 PSI maximum
- Weight: Approximately 50 lbs
- Length: 10 feet
- Inside Width: 27 inches
- Outside Width: 35 inches
- Seating: Built-in inflatable chair
- Motor Compatibility: Electric fin drive (sold separately)
- Rear D-rings: For optional motor mount installation
- Included: Manual hand pump only
- Recommended: Optional electric air pump for easier inflation
IMPORTANT: This is a USED demonstration sample, NOT a new production boat. Electric fin, motor mount, transom adapter, and other accessories are NOT included unless specifically stated.
SAFETY WARNING: Always wear a properly fitted life jacket and carry a spare SUP paddle in case the electric motor stops working. Use only in suitable water and weather conditions.